What do I do if my Aguri Power Clean pressure washer won’t work from a bucket?
Follow the instructions below if your Aguri Power Clean cordless pressure washer will not draw water directly from a bucket the first time you use it.
- Check that the end of the hose with the filter attached is completely submerged and shake the filter to ensure that any air bubbles are released.
- Check that there are no kinks in the short hose pipe supplied and that it is securely connected to the gun – and remember that it can take up to 20 seconds for the water from the bucket to make it’s way up the hose and reach the gun.
If your Aguri Power Clean cordless jet washer will still not draw water from a bucket you may need to run some water through it using a normal household hose pipe as follows:-
- Connect your Aguri Power Clean to a normal household hose pipe and turn on the tap (Please note that water will start to come out of the washer immediately, so ensure that the gun is not pointing at anything you do not want to get wet)
- Power the gun by pulling and holding the trigger for approximately 2 minutes.
- Turn off the tap and disconnect the hose pipe from the gun.
- Re-connect the short hose pipe supplied, fully submerging the filter end in a bucket of water and shake the filter to ensure that any air bubbles are released.
- Pull the trigger and your Aguri Power Clean should now work normally. Please remember that it can take up to 20 seconds for the water from the bucket to make it’s way up the hose and reach the gun.
How do I know when the battery on my Aguri Power Clean pressure washer is fully charged?
First generation battery.
Press and hold the button on the front of the battery and the LED indicators will confirm the current battery status. If the red and two green LEDs are illuminated, the battery is fully charged. When only the red LED is illuminated or when no LEDs are illuminated, it is time to recharge the battery.
Second generation battery.
Press and hold the button on the front of the battery and the LED indicators will confirm the current battery status. If three green LEDs are displayed, the battery is fully charged. If no LEDs are displayed, or only one, the battery capacity is low and it is time to recharge it.
If you need any further help or information about this product please call 0330 102 5578.
For more information view our range of Aguri Power Clean cordless pressure washers.
